Feb 02 2020

Fusing Offset function shifter or finisher required 2 Ozone level Mix paper feed Yes Only when this function is set Preheating Yes Conditions are set with the key operator Ozone Less than 0. When this simulation is canceled, the display is shifted to the ini- tial menu, but the machine is not reset. Check the grounding of the copier. Check Check the destination information of the operation panel unit and the MCU. Page 73 PD sensor detection level Hexadecimal display The value in [ ] shows the threshold value. The optimum paper tray for the scanned size is selected.

Uploader: Yogis
Date Added: 5 February 2010
File Size: 38.30 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 53360
Price: Free* [*Free Regsitration Required]

Use remedy SIM for the destination of the body.

Sharp NROLMQSZZ, Upper Fuser Roller, AR M, M, MX M, M Original

Other precautions Page 21 – Developer cartridge installation Page 22 – Toner density sensor level adjustment Page 23 – Installation of options Page 24 – B.

Executable only when the FAX 2m56 installed. The contents are subject to change without notice. Add to my manuals Add. Page 5 Upper sheets tray paper feed a.


A3 The A3 size print measures If, for example, the grid high voltage is set to —V pattern 1the —V —V grid low voltage is —V. Enter the new setting and adjustment values.

Before removing the left cover, remove the No. Enter text from picture: Regular paper and special paper such as transparency film can be fed from the bypass tray.

Page 40 Set value mode range Original off Single: Overcurrent to the motor. Similar to procedure 6, adjust SIM Item 8, 9 so that the left 2 Horizontal adjustment Horizontal, vertical edge void is the specified value. Others Troubleshooting Page – B.

Other modes The mm256 is made according to the selected mode and the item.

When, therefore, the simulation is canceled by pressing the [CA] key or when the copy mode display is shifted to the initial menu dis- play in the simulation mode of one page copy, the machine is reset.

No setting The output image direction is AR changed in the staple mode of the finisher.

Hexadecimal display For AB series, 1 to 5 is displayed, for inch series, 1 to 4. For this operation, the protocol monitor of one communication is always buffered.



Page 42 “2” is copied. Side door unit Page – G. Internal Structure The fusing unit is hot. Internal structure Page 29 – C. Page – C.

Page Check the grounding of the copier. Have drivers MFP or printer for the functioning of the j256 system. Danger of explosion if battery is incorrectly replaced. Use SIM to check the slide motor Overcurrent to the motor. Used to check the LSU polygon motor operation. That standard is ISO ppm.

Sharp AR-M256 Service Manual

The tray settings screen will appear. The display is shifted to the copy menu. The relative distance for the height of the tray standby position in non-stapling is set.

This key blinks when auto power m2256 mode has activated. When inserting a thickness gauge, be careful not to scratch the developing doctor and the MG roller.