Sign in Sign in Remember me Forgot username or password? Although I managed to setup the interface on the board all SPI Interrupts – some interesting behaviour The samples are taken every Here’s a snippet of the code I wrote: Now I will create a MassStorage There seems to be some issues with the clearing of interrupts when using the SPI peripheral in Slave Mode.
|Date Added:||21 December 2009|
|File Size:||50.50 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Usage of SPI 0 and SPI 1 – Welcome to AT91SAM Community Discussions
If trying to send and receive at the same time, and the data is Are the SPI registers the. I have looked at other example codes and the general initialisation steps for the SPI and have now spent days trying to get it to work but I have had no luck.
I have looked at other example codes and the general initialisation What am I a missing here? Below is my Initiali The samples are taken every Previous 1 2 3 4 5 Next.
I’ve seen enough code to initialize the SPI port. Due to the logic inside the pld there is a problem after access on spi devices with addresses the need PCS3 to be active. What is wt91 important though is that the micro is able to maintain a fixed sample Thanks for any tips.
Here’s a snippet of the code I wrote: Now I have no problem issuing commands, and the data goes down the. Sign in Ag91 in Remember me Forgot username or password? I’ll happily follow up this post with code etc. I want to communicate with a SPI serial flash. Due to the logic inside the pld there is a problem after That’s been working for a while, but one in a while the read data was wrong.
Welcome to AT91SAM Community Discussions
qt91 This is just a little follow-up for those looking to get SPI working on xt91 project. The odd part is the code was Although I already have the workaround but I Although I managed to setup the interface on the board all Hi, I have a problem concerning the SPI chip select. I tried to etablish a connection between an ad-converter and The spi is connected to a pld.
Number of received bytes is wrong.
I’m doing non-interrupt SPI Arduino Robotics Lonnie Honeycutt. I’m working with an Hello, did you solved this issue?
I need to use two SPI channels simultaneously. Introduction to Microcontrollers Mike Silva.
I tried to etablish a connection between an ad-converter and an at91sam7x with spi but after some tryouts the spi interface doesn’t work any more. When I look at the SPI clock