Be the lights at the end of the tunnel.
How to wire roof lights fj cruiser.
Toyota fj cruiser 2007 air dam light bar procedure page 10 of 24 pages dio issue.
Off road only provides 6 lights a switch and the required wiring in the under chassis kit.
Line one of the light bar end caps with the top hole that you just removed the plug from.
I wired my lights through the roof rack bar over the drivers door.
Hi i want to share the process on installing piaa fog lights on my fj cruiser 6mt 2013 the goal here was to do it without drilling a hole in my ride besides two small ones to mount the lights on the stock bumper.
2 19 2 clean roof panel around the roof rack foot pad with 3m prep sol 70.
Partol 52 inch straight curved light bar mounting bracket fit 2007 2014 toyota fj cruiser steel metal upper roof windshield led light bar mounts pair black 4 4 out of 5 stars 16 27 90 27.
Once you pry them up use needle nose pliers to pull them out com pletely.
They also recommend the lights be located with one in the front center behind each front tire in front of each rear tire and one centered in the rear.
Reach the lights at the end of the tunnel or better yet.
So i do my research on the fj cruiser forum and on the web.
This configuration will fully light the underside of the fj.
I had to drill another hole but at least it is not a hole 3 inches from the roof rack bracket like the trd instructions say.
I m pretty sure i drilled the hole between the two stock bracket mount bolts underneath the plastic bracket and rubber seal.
Check out this video tutorial to see how to install off road lights onto a toyota fj cruiser.
T installation of roof wire harness.
The wiring from the light bar.
Side of the factory roof rack as shown.
1 place towel under front portion of headliner to catch metal shavings.