Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
How to intall a metal ribbed tin roof panels.
To guard against wind damage at the eaves and for a neatly finished appearance gable trim is recommended.
Measure the length width and rise of one section your roof.
The panels overlap allowing water to flow from one panel to the next without being able to penetrate the area under the roofing panel.
No sales pitch or other fluff.
Just simple 3d animated digital instructions on how to install union s masterrib metal roof panels.
At this point chalk a line from ridge to eave.
Install the roofing screws vertically along each rib in the panel.
Lay the roofing felt.
Corrugated metal roof installation instructions.
Without getting up on the roof itself you can get the measurements simply by measuring the length and width of the.
You can always install this foam on the inside and outside of the sheath.
Butyl tape as shown below is recommended along panel side laps.
Install screws every 6 10 inches.
It is extremely important that this panel be laid square to the eave and ridge so that the remaining panels will line up square on the roof frame.
If you must climb onto the roof to measure the space be.
Place the leading edge of the first panel along this line.
Before you can begin to update your roof you will have to get an accurate.
Lay and secure the first metal.
The installation of metal roofing involves placing large metal panels on the roof.
Another option is to install a or 7 8 lap stitch screw in the crown of the rib to secure the side lap.
Masterrib is a 36 wide 5.
Measure one panel width in from the roof edge.
Always try to measure from the ground first in order to keep yourself safe.
As a first line of defense against water damage it is important that the metal roof overlap be implemented correctly.
Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart.
It can be touted that foam batting material is the best one to pair with metal roof insulation.
It is not the normal insulation type that can be rolled up.
This is part 1 of a 6 part video series explaining how i installed a metal roof on my house.
To install corrugated roofing start by cutting your panels to length with an angle grinder.
Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses.