Click the links below to see inside dus.
How to put up plastic gutters by yourself.
Run the bead up both sides.
From the end of the receiving gutter.
Add a bracket every 20 to 24 inches.
The home mender dustin luby shows us how to install new gutters with ease.
Attach a drop outlet at the far end of the roof line.
Hold another elbow against the house and cut a piece of downspout to fit between the two elbows.
Move to the downspout end and measure down the same distance and mark it.
Things you ll need extension ladder that reaches at least 3 feet 0 9 m above the edge of your roof tape measure chalk line powered screwdriver or cordless drill 1 25 inch deck screws hacksaw or reciprocating saw vinyl gutter kit or the following items.
More diy home improvement projects.
Gutter sections for gutter run you measured.
Begin by applying a heavy bead of lap sealer with a caulk gun at least 4 in.
A gutter connector marries two sections of gutter.
Screw it to the fascia board.
Cut a four inch long notch to overlap and splice together gutter sections.
Installing the gutters start at the end of the gutter away from the downspout location and measure down 1 2 inch or the distance recommended by your gutter manufacturer and make a mark.
Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section with an inside or outside corner piece.
These two marks should be level with each other.
Attach the first gutter hanging bracket 4 inches in from the original end of the roof line.
All gutters are attached to your house by mounting system or different types of hangers inside outside or strap and the hangers need to be carefully spaced close together 3 feet or less to give the gutter proper support.
Fasten the parts together with pop rivets or screws.
Attach a gutter connector to the fascia with screws every 10 feet.
Of overlap snap the front flanges together and screw the overlap together with sheetmetal screws.
Then set the new length of gutter into the installed length with about 5 in.
Screw a downspout elbow to the outlet tube protruding down from the gutter.
Afterward insert a 1 inch 2 5 cm 8 32 stainless steel machine screw through the hole and cap it with a flanged nut to secure the gutter to the bracket.
Secure the gutters to the fascia brackets using machine screws.